#WET BLASTER NOZZLE DIAGRAM DOWNLOAD#

Variety of waterjet nozzles to optimize the sandblasting performance of your. The Abrasive Application Unit converts your Hydroblaster or other high pressure. A 1/2' nozzle is sufficient to produce an effective blast pressure with a 375 CFM compressor.

#WET BLASTER NOZZLE DIAGRAM DOWNLOAD#

Check out our nozzle size infographic, and click the image to download and share nozzle. In addition, the presence of lubricating water reduces heat due to friction that can warp metal surfaces. If you dont choose the right nozzle size, your production will suffer. Vapor abrasive blasting is a preferred method for blasting antique, fragile surfaces and soft surfaces (including wood). A 3/8' nozzle is sufficiently constricted to produce an effective blast pressure with a 185 CFM compressor. Wet blasters can operate effectively at lower PSI, removing coatings without damaging the underlying substrate. NLB wet abrasive blasting systems combine the force of a high-pressure water jet with. For vapour abrasive blasting, the most commonly-used nozzle orifice sizes range from 3/8' inner diameter to 3/4', increasing by increments of 1/16'. Water hose: 3/8” ID x 50 ft, rated 1000 psi. NLB Corporation is an industry-leader with innovative water jet nozzles. Fittings: ½” air inlet, ¾” water inlet, ½” teed to two ¼” main water outlet connections ¼” individual water outlet. During blasting, water flow can be adjusted to use just enough to control the dust for wash-down, water flow can be adjusted to a maximum flow of 2.8 gpm. of water into the high-velocity abrasive/air stream just before the nozzle. Water consumption may be slightly higher or lower based on variables such as nozzle size, blast pressure, condition of surface, material being removed by blasting, and friability of the abrasive. Clemcos Wetblast Injector System (Water Blaster) adds the dust-suppressing. Water consumption is controlled by a needle-valve - approximately 0.25 gpm at 60 psi during blasting. WetBlast Injector Pump Module: Nozzle injector body, water hose and air-operated self-priming injector pump, which consumes 28 cfm at 100 psi.

Remote Controls: Pneumatic-type: Millennium Inlet Valve, TLR Outlet Valve, RLX Control Handle, Abrasive Cut-off, 52 ft twin-line hose, 52 ft ACS hose.Blast Machine: Model 2448, 6 CF capacity, with 1¼” piping, built to ASME-code, National Board approved, rated 150 psi maximum working-pressure.Comes with two injector assemblies (50mm Contractor thread), one that can be located at the metering valve an alternate that can be located at the nozzle.Allow for frequent start/stop, maintaining lower blast pressure.Features an extended blasting pressure range of 5 to 120 psi.When wet blasting, operators can set and immediately see any change in water flow by using the gauge readout. Clemco LP FLEX 2448 Base Unit |(pressure range 6 to 120psi) Blast Helmets Hoses, Nozzles & Couplings.

Wet blaster nozzle diagram